vehicles for maintenance and repair of city roads

Prohibitions in the operation and maintenance of rotary plow

November 14, 2008 | Filed under: Mednitskii, sheet metal, and the wallpaper department derevootdelochnoe
(Not yet rated)
Загрузка ... Loading ...
Prohibitions in the operation and maintenance of rotary plow

For operation and maintenance of rotary plow is prohibited: 1) to be near his people working body, 2) snow plow when the device is working fixing bodies in the transport position, and 3) to approach the working part of the neck of the casing of the rotor and the rotating auger or cutter closer than 3 m, 4) to repair anything under the hinged part of the rotary plow in the absence of reliable supports, as well as lubricate, adjust, clean screws, etc., with the engine running.

Safety measures for maintenance of machinery for the collection and transportation of waste. Before leaving the container garbage truck to the line must be satisfied in full its good, and the need to check: 1) the reliability of the hydraulic device, the mechanism of stabilization springs, swivel and boom gidrokrana 2) the work of PTO and hydraulic pump, and 3) fixing the base platform to the machine frame and container on the platform. When loading containers need to install the machine at a minimum distance from them to ensure the safety of the crane. Before you start the car gidrokrana should be put on the handbrake, and include a mechanism for stabilizing springs. During the preparation of the container to rise to watch out for his mount and avoid lifting poorly captured by the container: the container must be raised to 0.5-1 m and see this, then continue to rise.

For operation and maintenance of the truck container is prohibited: 1) tighten the connection of hydraulic system during operation, and 2) to stand in the turning area at the time of loading and unloading of containers and container tilting platform, and 3) movement of the machine locks with open containers and hinged mounting platform; 4) allow unauthorized persons in the area of ​​the crane; 5) to the mounting-regulation works in the raised boom with the load, 6) lifting weights, weight lifting capacity in excess of 7) working with a faulty valve.

After loading the car and before the unloading of containers to check their attachment to the platform. In overturning the platform is allowed to use only the remote control (levers) located behind the cab. When overlaying the capture of the container to make sure that reliably capture squares by regiments went over the side container.



We recommend to look

  • Operation of Watering-washing machines with a defective bracket Tank
    Operation of Watering-washing machines with a defective fastening the tank valve or damper central nozzle is prohibited. For operation and maintenance of watering-washing machines are prohibited: 1) check the oil level, fill the oil, pull the seal during operation of a centrifugal pump, and 2) to move the machine with the sleeves neulozhennymi diversions, 3) fill the tank with water from the water with the engine running the machine. It is strictly forbidden to perform at [...]
  • Before leaving the truck car body on the line
    Before leaving the truck car body on the line to check: 1) the oil level in the tank, and 2) the work of PTO, the mechanism of movement control, and pushing the plate cylinder tilting mechanism, and 3) the reliability of fixed stops turning, and 4) the serviceability elektrosignalizatsii 5) seal control valves pushing plate and tilting mechanism and hydraulic joints. When operating the machine should be systematically checked the serviceability of [...]
  • The requirements for cleaning the site
    Areas to be cleaned is selected with the following requirements: 1) the width of the strips should be harvested throughout the area to provide the same or a combination of rational use of machinery after harvesting the widest thoroughfares, and 2) the intensity of vehicular traffic within the site, as well as its level of accomplishment should be equal, and 3) the snow should be removed one way, [...]
  • Dump trucks, snow waiting to be loaded
    Tipper, awaiting the loading of snow, the snow should be placed along the shaft to move snegopogruzchik working on them. If a big snow dump interval, awaiting loading, impede the movement of trolley buses, with the permission of the chief or master, they can stay on the cleaned stripe. Movement of truck backing toward snegopogruzchika can be done in this case only under the supervision of the worker. The next [...]
  • Sweepers
    As the operational practice of cleaning contamination on prilotkovoy band and sweeping pavements, location of the machine has a significant impact on a number of settings and modes that determine its operational performance. Influence of location of the machine, in particular, the effect on weeds, sweeping velocity, which decreases sharply when working on prilotkovoy band, due to the fact that it [...]

Leave a comment