Sealing device for loading the body waste and the coupling with the semi-trailer is out of the bunker, coupling, seals, hydraulic cylinders (power and idling). Bunker - welded steel plate to which are welded stiffeners. Its design provides for the collection two rails connected by cross-bar, on the right and left side fixed coupling device mounted inside the seal, moving along the body when subjected to a sequential two hydraulic cylinders. Coupling Device provides trailer hitch, and the sealing device is welded to the walls of the bunker on both sides.
Seal - welded frame on which are fixed two frames, moving the nomination rod power and idle cylinders. It provides loading and compaction of waste.
To prevent waste compactor during the loading on the cutter is installed. Hydraulic cylinders (power and idling) pivotally attached to the hopper and gasket.
The truck trailer consists of a body, the rear suspension with brakes, pneumatic actuator brakes, supporting device, doors, boot lid window buoyancy panels and electric, lighting and alarm systems.
We recommend to look
- Management of special equipment
All management of special equipment is located in the driver's cab. The torque from the motor base unit is transmitted through the PTO, protective sleeve, hand-outs and conical gears on the drive shaft and the shaft of the conveyor screw feeder, as well as to drive the main brush. The second (upper) power takeoff shaft is used to drive the oil pump gear. Hydraulic drive car is [...] - Sidewalks-sweeper TUM-975
Sidewalks-sweeper TUM-975 has special equipment mounted on a special self-propelled chassis, performed on three-wheel circuit with front drive and rear steering axles, which consists of a dual wheel. Daylight saving equipment consists of two main chute and a cylindrical brushes, hopper, and estimates of the type of pneumatic dust control. At the bottom of the hopper set screw, which provides unloading of [...] - The composition of the device podmetatelnogo
Sweeping device consists of a main cylindrical brush located behind the rear wheels of the machine, and two socket (tapered) brush trough located between the front and rear wheels on both sides of the machine, which allows two-way streets clean, and one-way transportation (moving cleaning machine direction of traffic). Flume brush grabs debris from areas prilotkovoy have [...] - The drive compressor
The drive is made from the compressor PTO engine GAZ-53A through the gearbox, driveline and transmission belt. On the gear drive compressors mounted gear pump NSh-10E, which serves the work of hydraulic machines. In the working position hopper hydraulic cylinder rises thermos, allowing automatic translation of the bucket truck-mounted on the rear bodywork and manual vibratory rollers of the transport to working position. Bucket-truck [...] - Crane M-30
Crane - turning, lifting capacity of 0.5 tons installed on the right side of the machine during on-site back cover. Up and down arrow of a hydraulic cylinder, installed inside a rotator. Turn "by crane from the motor shaft through a worm gear by a mechanism located inside the rear door frame. Pushing plate - a curved steel plate, reinforced with ribs. [...]
Loading ... 
