Gas infrared heaters are simple devices and services, low thermal energy, regulation of output power over a wide range by changing the gas pressure supplied to the mixer burner. Disadvantages of - the possibility of blowing the flame with wind speeds of more than 6-8 m / s, relatively short period of service, additional activities on safety, as support staff to work [...]
July 30, 2009 | Categories: Vacuum machine KO-705ANM | No Comments
The energy balance of these machines in operation include (depending on the technology works): the cost of power to drive the bitumen pump, defined as vehicles for transporting and distributing bitumen, cost of power to drive the compressor is defined as machines that destroy the hard cover, the cost of power to drive the mixer to be taken when mixing the mastic in the boiler with a capacity of [...]
July 28, 2009 | Categories: Vacuum machine KO-705ANM | No Comments
Operation of Watering-washing machines with a defective fastening the tank valve or damper central nozzle is prohibited. For operation and maintenance of watering-washing machines are prohibited: 1) check the oil level, fill the oil, pull the seal during operation of a centrifugal pump, and 2) to move the machine with the sleeves neulozhennymi diversions, 3) fill the tank with water from the water with the engine running the machine. It is strictly forbidden to perform at [...]
July 27, 2009 | Filed under: Mednitskii, sheet metal, and the wallpaper department derevootdelochnoe | No Comments
Minor damage to the surface of curbs corrected as follows. The surface is carefully cleaned of dirt and dust, mechanical brush and washed with 30% solution of hydrochloric acid. Brush or spray applied to the cleaned surface of colloidal cement glue and immediately hand-sealed with a mixture of tsementopeschanogo damage the concrete. The mixture should act on the damaged surface by 20 - 26% of the depth of destruction. [...]
July 26, 2009 | Categories: Technology Basics mechanized operations technology content of the work | No Comments
Great importance should be given to developing ways to improve ergonomics and environmental properties of the machines that are designed to: provide operator comfort by installing adjustable seats, adaptive control levers, etc., to reduce vibration and vibration through a special device cab suspension, seats with an active damping system low frequency oscillations , etc., to reduce fumes and dust content of air in the cabin, to improve its sound insulation, [...]
July 22, 2009 | Filed under: Techno-economic evaluation and optimization of work | No Comments
Office cleaning equip sump, oil benzoulovitelyami that periodically purified by Cesspool emptying and mud pumps. Number of posts on the mechanical cleaning spetsavtobaze determined by calculation.
The first and second technical service. They (TO-1 and TS-2) is performed to reduce the intensity of wear parts, identify and prevent failures and malfunctions promptly performing diagnostic and control, lubricating, fixing, adjusting, and other works. [...]
July 16, 2009 | Filed under: Performance cars | No Comments