Applied to the brush sweeper brushes are divided into cylindrical, conical and flat or conveyor. Cylindrical brushes can be with a solid pile arrangement, paniculate, or sheaf. They are used for sweeping the pavement and supply estimates for the transporting device, or directly into the hopper.
The fan and water pump is driven by a gear box change PTO, driveshaft, and V-belt transmission. The driving pulley belt transmission is connected to the fan drive roller overrunning clutch, which turns off the fan from the transmission in case of sudden braking. Drive trough the brush - from the motor through a spur gear, the center - directly from the motor. Hydraulic drive machine is used to drive the working bodies, raising and lowering the operating position of brushes, locking the back door bin, moving the hopper in the inclined position when it is unloaded.
The hydraulic system consists of a gear pump, axial piston hydraulic motors, valves, filters, chokes, hydraulic cylinders, hydraulic lines connecting. Humidification system includes water pump, water tank with a capacity of 760 liters, the filter sump, jets, suction and discharge piping and valves control the flow of water. Water enters the suction pipe and pump the water is pumped under pressure from 0.25 - 0 3 MPa to the nozzles of the central trough and brushes, and a nozzle pickup.
We recommend to look
- Hinged hopper to the subframe
hinged hopper to the subframe, the state of the suction hoses and gaskets, hose and nozzle fan in the hydraulic system and humidification system - the state oil lines, hydraulic motors, hydraulic cylinders, nozzles, valves and piping system for leaks and moisture, hydraulic locks work gutter brushes transport position, the oil level in masloblokah, the action of water level indicator in the [...] - The drive compressor
The drive is made from the compressor PTO engine GAZ-53A through the gearbox, driveline and transmission belt. On the gear drive compressors mounted gear pump NSh-10E, which serves the work of hydraulic machines. In the working position hopper hydraulic cylinder rises thermos, allowing automatic translation of the bucket truck-mounted on the rear bodywork and manual vibratory rollers of the transport to working position. Bucket-truck [...] - Control osmotrovye work for watering, washing machines
For watering, washing machines hold control osmotrovye work (check the backlash in the joints and spline drive shaft connecting the drive centrifugal pump, and the state of painting special equipment) and check the major parts and assemblies: remove the lid and remove the sump tank sucks, check the tightness of its central valve mounting impeller and the state of the driven shaft seal water pump. For sweepers spend [...] - Winter equipment machines KO-708
Winter equipment machines KO-708 consists of a plow, brush and cylindrical hopper-spreader. Plow blade with a rubber knife, mounted on the front of the lift frame chassis with software manually turning it left or right while moving. Up and down the plow to the vehicle and the working position by means of hydraulic cylinders. Winter equipment consists of a brush, and frame her head [...] - Management of special equipment
All management of special equipment is located in the driver's cab. The torque from the motor base unit is transmitted through the PTO, protective sleeve, hand-outs and conical gears on the drive shaft and the shaft conveyor screw feeder, as well as to drive the main brush. The second (upper) power takeoff shaft is used to drive the oil pump gear. Hydraulic drive car is [...]
Loading ... 
