Repairable coating after it is clean and warm up the block layout of burners: the whole area - the repair of small cards, and on the perimeter of the marked path - in the repair of large maps.
After the backwash rakes heated asphalt concrete pavement to a depth of 3-4 cm and supplements in the recommended location of the new material from the hopper, a thermos is a new material is mixed with the heated mixture of old and sealed edges to the middle of the repaired spot. Places pairings of old and new 166
coatings are heated with a ruler burners. During the repair coating temperature should be between 130-150 ° C. The duration of technological operations after the warm-up before rolling cover the repair area to ensure the preservation temperature of heated asphalt concrete not less than 100-140 ° C.
After finishing work hand-roller and block burners installed in the transport position.
Body asfaltorazogrevatelya serves to accommodate the working equipment. In the front part of the cabin is equipped to carry two people. Block Burner is a metal frame, with the gas contained therein burners, infrared radiation. When heating the surface of the block covering the burners should be parallel to the surface. In the transport position block burners has a vertical position. Raises and lowers the power burner with hydraulic drive. The range burners is a metal frame with reinforced it in a number of gas burners, infrared radiation. In the transport position is within the range of body (left side), which is also installed with cylinders with liquefied gas (for power supply unit and the line of burners), electro-roller.
Alternator type EC-52-4u2-M101 is used to power elektrovibrokatka. The drive of the generator from the power takeoff engine.
We recommend to look
- Remixer
Remixer - is, in fact, the car "Repaver", equipped with additional dosing and mixing units. Warmed up the old asphalt coating loosen knives, and then screw valve and located behind the blade is fed into the mixing unit equipped with two shafts. Fresh mix from the hopper conveyor enters the dosing unit, which sends it to the mixer, where the old and the new mass [...] - The drive compressor
The drive is made from the compressor PTO engine GAZ-53A through the gearbox, driveline and transmission belt. On the gear drive compressors mounted gear pump NSh-10E, which serves the work of hydraulic machines. In the working position hopper hydraulic cylinder rises thermos, allowing automatic translation of the bucket truck-mounted on the rear bodywork and manual vibratory rollers of the transport to working position. Bucket-truck [...] - Machine DE-5A
Machine DE-5A is intended for maintenance of city streets and highways with asphalt. Special equipment vehicles placed on the chassis of GAZ-53A and consists of a hopper-the thermostat for the transportation and storage of hot asphalt mix, with pneumatic compressor, gas equipment - block infrared burners, tanks, hoses, hand tools for painting and road conditions [. ..] - Bunker thermos
Hopper provides storage thermos of hot asphalt mix. The mixture is fed into the truck through the open (with cylinder) hopper bin, after which the mixture is transported to the site of work. The torque from the surface of the power takeoff shaft, flanged to the gearbox base unit is transmitted to the input shaft of the hydraulic pump, and from the bottom of the shaft - the input shaft of the generator [...] - Generator ESS-81-4
Generator ESS-81-4 provides 20 kW of electricity consumers. The drive of the generator from the motor shaft base unit via PTO, driveshaft, intermediate support and the V-belt transmission. The compressor provides the blasting and spray charts. Elektrovibrotrambovka designed to seal freshly placed mass with a width of the repair area is less than 500 mm. Elektrovibrokatok used to seal freshly placed mixture to [...]
Loading ... 
