Road-building equipment

When working with gas burners razogrevateley type of radiation should be opened before the ignition supplies valves on cylinders and gazoraskhodnoy column and gauges to check the pressure in the systems of medium and low pressure, medium pressure shall not exceed 0.16 MPa, the low - 0,002-0,0035 MPa . After checking the pressure should be light igniter and bring it to the emitter of each burner. When the ignition burner valves on the unit should be opened sequentially only after the previous section. When the blue flame on the surface of the burner igniter must disable and remove it in place, after 40-50 seconds after the ignition burner to heat the radiators, thus it is impossible to prevent slippage and vibration of the flame in the burner. If you find faults (gas leak, uneven burners, etc.) must immediately stop the flow of gas to the burners, close the valve.

The smallest gas leaks, lack of tightness of the connection of cylinders, pipelines and valves is easy to detect with soap suds (obmylivaniem compounds).

Do not: 1 to check for leaks of gas and gas equipment flames, and 2) start the engine and run in the presence of a gas leak, and 3) Keep away from flammable materials employed asfaltorazogrevatelya 4) to leave the burner unattended and remote operating range, as well as working with power burners and bypass line, if there is a burning flame burning or breakthrough on the nozzle, or a damaged ceramic infrared burners on;

5) be in an area otzhigatelya at work, and transportation;

6) observe the burner flame behind an umbrella (you need only watch through the viewing hole in the side walls of the hood).

We recommend to look

• Universal Loader
  The working body of the universal loader - Mill, ensures the development of loading a relatively dense mass of various bulk materials, as well as the snow for a long time was in the shafts, that is their advantage in comparison with the widespread snegopogruzchikami working Tine body type. However, the realization of the benefits of operating conditions is possible only with careful adjustment of the working body in the [...]
• Technology repair roads
  When using the roads to cover the exposed from moving vehicles, and various climatic factors, etc., which causes deformation of the destruction and deterioration of the coating. Faults of pavement, leading to a decrease in the performance of a road, remove the repair work. There are current, average and major repairs of roads. Current repair performed mainly in the warmer months, at [...]
• The drive compressor
  The drive is made ​​from the compressor PTO engine GAZ-53A through the gearbox, driveline and transmission belt. On the gear drive compressors mounted gear pump NSh-10E, which serves the work of hydraulic machines. In the working position hopper hydraulic cylinder rises thermos, allowing automatic translation of the bucket truck-mounted on the rear bodywork and manual vibratory rollers of the transport to working position. Bucket-truck [...]
• When the ignition nozzle
  When the ignition fuel nozzle, first served a weak jet, with a gradual increase in its back to normal. Light jets only need a torch with a long handle (1.5-2 m). Stir and adjust the nozzle should be, being on the side. Prior to the filling of binder needed to pay off and close the nozzle valve fuel supply pipe. When breaks in the asphalt distributor nozzle distribution [...]
• Optimizing the use of machinery
  Work on the maintenance and repair of city roads all run in large volumes, which is caused by urban growth and accomplishment. The latter circumstance leads to a significant change in the operational background, in which the work of the special-purpose vehicles. The growth of cities has caused, of course, a significant increase in their area and, consequently, the time spent on unproductive travel, has risen to a prominent place [...]