Road-building equipment

When servicing the power supply system and electrical leak check the tank and connection piping supply system, fixing the carburetor, fuel pump, pressure gauge, the fuel pump, the ease of starting and engine operation, fuel consumption when driving a car on the dimensional plot, carburetor parts, including jets (with special devices). 2 times a year removed from the engine carburetor, disassembled, cleaned and washed, check the limiting speed of the engine crankshaft. In accordance with the upcoming season, 2 times a year, adjust the accelerator pump carburetor and fuel mixture is heated in the inlet pipe. In the autumn a survey once a year, remove the fuel pump, check the condition of parts and its work with special instruments. Fasten the battery in the socket and check the degree of charge. 2 times a year, check the density of battery electrolyte (density should correspond to the season). Clean the outside surface of the generator, starter, relay control of dust, dirt and oil. Check the starter mount, the state of the collector and brushes of the generator, the generator chamber is purged

compressed air. Check the relay controller, the state of the collector and brushes of the starter, the starter cavity is purged with compressed air. Lubricate the bearing starter. Cleaned surface of the candles and the ignition coil high voltage from dust, dirt and oil. Remove the spark plugs, check their status, if necessary, cleaned of soot and adjust the gaps between their electrodes. Read the breaker distributor, clean its outer surface from dirt and oil, check the condition of the wires of high and low voltage installation, mounting and operation of the headlights.

We recommend to look

• Milling Machines Rotary Equipment CO-705
  Milling Machines Rotary Equipment CO-705: prior to placement on the long-term storage of dismantled vehicles equipment, wash it, wipe and check the technical condition and if necessary repaired. After cleaning, check the status of weld metal, the completeness of equipment and color. Replace the oil on schedule in the conical and cylindrical gear drive milling (oil is poured to the level of filler plug) remove the hydraulic [...]
• Removal of snow and ice formations
  Snow-ice formation can be removed bezvyvoznym, export, or a combination of ways. The most inexpensive way to bezvyvozny, where the snow is stored on the free areas of the road. On wide streets with relatively low intensity of traffic the snow can be stored until the end of the winter season prilotkovoy or dividing bands. You can also use (in coordination with relevant organizations) of the band occupied by vegetation. [...]
• Maintenance and repair of desktop equipment special-purpose vehicles
  In the operation of units and units of special vehicles wear out, reduced the strength of parts, rubber parts are destroyed. All this leads to breakdowns, increased consumption of fuel and lubricants, machinery downtime to repair and reduce their productivity. Maintain vehicles in good technical condition must be due to timely and quality maintenance and repair. Maintenance is designed to maintain [...]
• Planning and records of maintenance and repair of machinery
  Planning and accounting are based on the annual production program, under which determine the number of employees working positions and areas of industrial premises. Maintenance positions calculated from the daily production program, expressed in number of this type of service (EG, TO-1 TO-2, CO), maintenance positions, as well as manufacturing sites - in the annual production program. The last set [...]
• Labor Standards TS-1 and TO-2
  Labor Standards TS-1 and TO-2 does not include the complexity of daily and seasonal maintenance. Standards of labor costs for technical or railway station are not included labor costs for ancillary works, which are set in the range of 20-30% of the total complexity of maintenance and minor repairs on spetsavtobaze (a smaller percentage adopted for large spetsavtobaz greater - for medium and small). The [...]