Road-building equipment

Machines of this type are the most difficult of all, used in cleaning the city roads, and their effectiveness largely depends on the working parts, operation and control.

The most important element of the machine, which provides separation of impurities and feed into the machine - brush device. With gutter brushes clean the most contaminated part of the road surface - prilotkovuyu band, so to set the brush so that its vertical axis was tilted back in a plane at an angle 45 ° to the longitudinal axis of the machine, so that in contact with the road was only half of the pile, the maximum strain which must be within the range of 30-35 mm. This setting chute brush provides good exposure to the most contaminated part of the road pile having a maximum deformation and a reliable supply of contaminants to the middle of the car. Home cylindrical brush must be installed in position, so that the maximum deformation of the pile was in the range of 15-20 mm.

We recommend to look

• Sidewalks-sweeper TUM-975
  Sidewalks-sweeper TUM-975 has special equipment mounted on a special self-propelled chassis, performed on three-wheel circuit with front drive and rear steering axles, which consists of a dual wheel. Daylight saving equipment consists of two main chute and a cylindrical brushes, hopper, and estimates of the type of pneumatic dust control. At the bottom of the hopper set screw, which provides unloading of [...]
• The composition of the device podmetatelnogo
  Sweeping device consists of a main cylindrical brush located behind the rear wheels of the machine, and two socket (tapered) brush trough located between the front and rear wheels on both sides of the machine, which allows two-way streets clean, and one-way transportation (moving cleaning machine direction of traffic). Flume brush grabs debris from areas prilotkovoy have [...]
• Sweeping equipment
  Sweeping up the equipment frame, tapered gear, cylindrical brush, chain drive with damper device chain hoist brushes. The brush is installed between the front and rear wheels at an angle of 62 ° to the longitudinal axis of the machine. The torque on the shaft of the brush is passed from the bottom of the shaft of the transfer case through the propeller shaft, conical reducer and chain drive. Frame brushes, consisting of [...]
• The curved shape of the brush
  The curved shape of the brush ensures the supply of snow in the middle of the machine on the conveyor. Drive back brush - mechanical. On the right spar chassis base parallelogram linkage is suspended flume frontal brush driven by a motor MNSH-46. Machines for the removal of compacted snow. They are equipped with special working bodies, allowing shear layer of compacted snow or ice to the structure, [...]
• The energy balance of machines
  The energy balance of these machines in operation include (depending on the technology works): the cost of power to drive the bitumen pump, defined as vehicles for transporting and distributing bitumen, cost of power to drive the compressor is defined as machines that destroy the hard cover, the cost of power to drive the mixer to be taken when mixing the mastic in the boiler with a capacity of 0.8-1 [...]