Road-building equipment

Before unloading truck asfaltoraskladchik need to put the parking brake. When lubricating the internal surfaces of the hopper should be out of the bunker. Tire pressure should be the same as specified in the instructions (memo) to care for tires asfaltoraskladchika.

Do not: 1) during the working stroke to remove the latch and drop the clutch, and 2) to work on the tires, having through-holes and damage to the cord, and 3) to be outsiders in the area of ​​the machine, as well as on-site management. Switched on and off working parts should be smooth (without jerks) motion controls. Ground control levers and steering wheel must be clean and dry. Do not clutter the site with foreign objects.

Before leaving the asphalt distributor of vehicle maintenance, check the reliability of fastening of distribution pipes and manual distribution. Before filling the tank, asphalt distributor mounted on horizontal surface and inhibit. You should check patterned hose and reliability of their accession to the suction port, as well as the purity of the filter in the receiver tube. Fill the tank only need a filter for small and medium-speed pump. Before ignition injector fuel line connection to test the reliability, serviceability of the fuel, the pressure in the tank, no drips and drops of bitumen in the furnace.

We recommend to look

• The drive compressor
  The drive is made ​​from the compressor PTO engine GAZ-53A through the gearbox, driveline and transmission belt. On the gear drive compressors mounted gear pump NSh-10E, which serves the work of hydraulic machines. In the working position hopper hydraulic cylinder rises thermos, allowing automatic translation of the bucket truck-mounted on the rear bodywork and manual vibratory rollers of the transport to working position. Bucket-truck [...]
• Washing machine for containers
  In applying the system for collecting and transporting waste to the non-replaceable bins or containers should be regularly washed the last on-site waste collection. Where there are appropriate opportunities to do so, bins and containers shall wash musoropriemnyh in chambers or in special washing areas, and where this is not possible - you need to use the washing machine. Asfaltorazogrevateli. So [...]
• Power AB-4T/230
  Power AB-4T/230 4 kW electric motor provides power to drive the compressor, bitumen pump system of distribution of binder and water pump "Kama-3" to feed 1.5 m3 / h, two elektromolotkov C-849 and elektrovibrokatka. The system includes binder heating fuel tank with pressure gauge and safety valve, piping, two-burner evaporative type. Bitumen boiler has an automatic control system heating mode binder. [...]
• The composition of pneumatic
  Pneumatic system consists of a compressor unit, a shut-off valve pnevmolinii compressed air into the fuel tank heating system bitumen pnevmolinii compressed air to blow out of hand valves, hoses, air nozzle and shut-off valve for cleaning cracks. Compressor station installed in the department spetskabiny and consists of a compressor-type 0-38B, the belt drive, ball-bearing rack with hydraulic motor [...]
• When the ignition nozzle
  When the ignition fuel nozzle, first served a weak jet, with a gradual increase in its back to normal. Light jets only need a torch with a long handle (1.5-2 m). Stir and adjust the nozzle should be, being on the side. Prior to the filling of binder needed to pay off and close the nozzle valve fuel supply pipe. When breaks in the asphalt distributor nozzle distribution [...]