cars for maintenance and repair of urban roads

Operation of Watering-washing machines with faulty mount tanks

Operation of Watering-washing machines with faulty mount the tank valve or damper central nozzle is prohibited. When operating and maintenance Watering-washing machines are prohibited: 1) check the oil level, oil fill, pull up seal during operation of a centrifugal pump, 2) move the machine with sleeves neulozhennymi diversions, 3) fill the tank with water from the water with the engine running the machine. It is strictly forbidden to perform [...]

Hydraulic power machines DE-210

Hydraulic drive machine allows raising and lowering the operating entity, as well as rotation of the rotor housing. Unlike hydraulic snowplow DE-210 is a design concept of separate hydraulic - hydraulic cylinders, control valve and hydraulic tank.
The base chassis is also modified for snowplow installation of special equipment - reinforced front springs, refined air system, chassis frame and some other elements.
[...]

Minor damage to the surface of the border stones

Minor damage to the surface of the stone-board fix follows. Surface thoroughly cleaned of dirt and dust and mechanical brush and washed with 30% hydrochloric acid. Brush or spray applied to the cleaned surface of colloidal cement glue and immediately sealed by hand with a mixture of tsementopeschanogo damage the concrete. The mixture should appear on the damaged surface by 20 - 26% of the depth of destruction. [...]

Specialized positions

Daily maintenance of machines conducted by specialized mass-production positions, or dead-end method. Line method is recommended for medium and large spetsavtobazah (100 cars), a dead end - small (up to 100 cars). Each spetsavtobaze organized three specialized post daily maintenance: control osmotrovyh, cleaning, washing, fuel and lubricants operations.
All cars are returning to the garage after work, are subjected to inspection by the [...]

Motor mower SC-15

Motor mower SC-15 is designed for cutting grass on lawns, mounted on three-wheel cart that has a front drive axle with two wheels, rear - a piano, allowing its rotation. The basic working equipment ploskovraschatelnogo cutter type. Two-bladed knife drive is carried out on single-cylinder, two stroke, carbureted engine capacity of 2.9 kW (4 hp.). Is also provided on the mower [...]

Obmyvochnaya camera on CR-502

Rear of the machine is installed obmyvochnaya camera (for spraying high-pressure hose when you remove it from the well), it serves a water pump, water pressure of 0.5-1 MPa, which can be adjusted with a valve. Obmyvochnaya chamber consists of outer and inner cylinders, two rings that connect these cylinders, brackets and fitting.
Workflow control with the control panel, located behind the [...]

«Prev 1 2 3 4 5
...
39 40 Next »