Road-building equipment

The main features of the machine from the DE-5 model DE-5A - the presence of her benzoelektricheskogo unit and working with electrical equipment (compressor, elektrovibrokatka, elektromolotkov). The hydraulic drive hopper, a thermos and a rear side of the machine is provided with hydraulic cylinders, hydraulic pump mounted on the gearbox mounted on the gearbox car chassis, equipped with a mechanism of inclusion; drive the compressor and elektrovibrokatka elektromolotkov carried out from three-phase asynchronous motors with korotkozamnutymi rotors. Gas equipment of the machine consists of six cylinders for liquefied natural gas (propane), pipeline communications, pressure regulators, control devices and the gas collector, which with rubber hoses attached a length of 25 m 4 portable burner block infrared radiation (from the burner type TIG-1) .

Elektrovibrokatok equipped with a built-in drum-type electric vibrators IV-70, during compaction roller rolls seats repaired manually. The scope of work equipment is a machine gun spray gun type CO-71.

Used in the repair of road and paving asphalt pavement MTRDT machine has a working equipment mounted on the chassis of GAZ-53A, and consists of a hopper, a thermos, a body in front of which is available separately, bitumen tank, gidroizolyatora, electric irons, electric type of ESS-81 4, the compressor-type CO-7A, elektromolotkov type IE-4211; elektrovibrotrambovki type IE-4505, elektrovibrokatka, elektrorazogrevatelya, hand carts. Current repair of road asphalt pavement produced by cutting and heating cover maps of an area of 5 m2. Repair area previously cleaned with a scraper with a simultaneous supply of air from the compressor and dried elektrorazogrevatelem. Wall maps with insufficient heating straighten elektromolotkami. The treated card smeared with bitumen. With the help of an old pushcart is removed layer of the coating and bringing up fresh asphalt mixture. After placing and leveling the spike mixture of old and new sections provide a hot iron on a contour map. Maps of the width to 500 mm compacted elektrovibrotrambovkoy, and more than 500 mm - hand vibratory rollers.

We recommend to look

• The drive compressor
  The drive is made ​​from the compressor PTO engine GAZ-53A through the gearbox, driveline and transmission belt. On the gear drive compressors mounted gear pump NSh-10E, which serves the work of hydraulic machines. In the working position hopper hydraulic cylinder rises thermos, allowing automatic translation of the bucket truck-mounted on the rear bodywork and manual vibratory rollers of the transport to working position. Bucket-truck [...]
• Bunker thermos
  Hopper provides storage thermos of hot asphalt mix. The mixture is fed into the truck through the open (with cylinder) hopper bin, after which the mixture is transported to the site of work. The torque from the surface of the power takeoff shaft, flanged to the gearbox base unit is transmitted to the input shaft of the hydraulic pump, and from the bottom of the shaft - the input shaft of the generator [...]
• Asfaltoraskladchik ED-1M
  To lay the asphalt mix in small areas, as well as paving of streets and narrow passageways yard convenient asfaltoraskladchik ED-1M developed by Bureau Chief Control and Improvement of Road Management in Moscow. The basic chassis is the paver with a 4045M forklift forklift forklift dismantled, which is set to replace suspended frame (inside a framework for guiding movable frame is moved). On a mobile [...]
• Remixer
  Remixer - is, in fact, the car "Repaver", equipped with additional dosing and mixing units. Warmed up the old asphalt coating loosen knives, and then screw valve and located behind the blade is fed into the mixing unit equipped with two shafts. Fresh mix from the hopper conveyor enters the dosing unit, which sends it to the mixer, where the old and the new mass [...]
• Generator ESS-81-4
  Generator ESS-81-4 provides 20 kW of electricity consumers. The drive of the generator from the motor shaft base unit via PTO, driveshaft, intermediate support and the V-belt transmission. The compressor provides the blasting and spray charts. Elektrovibrotrambovka designed to seal freshly placed mass with a width of the repair area is less than 500 mm. Elektrovibrokatok used to seal freshly placed mixture to [...]