Road-building equipment

When working on the line driver must: maintain speed in accordance with the requirements of the Rules of the road, watching the testimony of the control devices of the car and the accuracy of all arrangements. When a fault in the car, threatening the safety and security of the car, the driver is obliged to take measures to eliminate the damage and if it is not possible to follow the nearest base district, to cause the machine technical assistance or return to the garage with the necessary precautions.

Before starting the engine the car should slow down, put the gear lever into neutral, start the engine with the starter to produce. Use crank is permitted only in exceptional circumstances, while respecting the following rules: 1) not including ignition and crank the crankshaft, making sure the shift lever is in neutral, turn the ignition 2) turn the crank from the bottom up, and 3) not to take the handle to grasp. Testing the brakes on the move can only be on level ground with a hard surface without potholes and slopes of not less than 50 m

When repairing the car on the line driver is obliged to comply with safety rules established for the repair and maintenance of the car in the garage. If the required repairs exceeds the allowable amount or the driver do not have the necessary devices and instruments, to repair the line is prohibited.

When repairing the car on the roadside to be prohibited under the car, breaking the boundary of the carriageway.

The driver is not permitted to repair the car people do not have that right.

Defective car towed vehicles only technical assistance, equipped trailed appliances. When towing must observe the following rules: 1) failure to use the brakes hard coupling, 2) for failure of front axle and steering the car to carry on the platform of another car, and 3) on the towed vehicle must be only the driver, others remain on the towed vehicle is prohibited!

In road accidents involving accidents, the driver commits an accident, shall immediately take the necessary steps to assist the victims.

We recommend to look

• The protective layer in the continuous shelling
  The protective layer in the continuous shelling suit after the removal of all defects of pavement - potholes, cracks, damage to joints, etc. This work should be completed well in advance for 2-3 weeks prior to the protective layer of the device. Prepared in this way cover with the help of sweepers thoroughly cleaned of dirt and cleaned the surface of the liquid is poured bitumen is heated to a [...]
• Downloads in the gritters
  To download gritters may be used only sifted sand, without stones and other large inclusions. Before loading the sand into the body gritters drive and feeders should be cleaned from the sand of frozen, fallen back stones and other objects. Particular caution should be observed for spreading sand of narrow streets, public transport stops, and places with large concentrations [...]
• Potholes and sinks
  Potholes and sink deeper than 5 cm after cutting remove and clean the place prepared by other means. The edges of the cutting and the bottom of the hydrate in water for several hours. On the wetted surface of a thin layer tsementopeschanogo solution. Then, in a cutting stack peschanobetonnuyu or cement concrete mixture and compacted it manually (rammers) or surface vibrators. The average repair [...]
• The energy balance of machines
  The energy balance of these machines in operation include (depending on the technology works): the cost of power to drive the bitumen pump, defined as vehicles for transporting and distributing bitumen, cost of power to drive the compressor is defined as machines that destroy the hard cover, the cost of power to drive the mixer to be taken when mixing the mastic in the boiler with a capacity of 0.8-1 [...]
• Generator ESS-81-4
  Generator ESS-81-4 provides 20 kW of electricity consumers. The drive of the generator from the motor shaft base unit via PTO, driveshaft, intermediate support and the V-belt transmission. The compressor provides the blasting and spray charts. Elektrovibrotrambovka designed to seal freshly placed mass with a width of the repair area is less than 500 mm. Elektrovibrokatok used to seal freshly placed mixture to [...]