Road-building equipment

Cars for winter harvest bins. Trays, prilotkovye areas of streets and roads clear of snow in the winter and from groundwater sediment in the spring and summer special machines, work equipment which is installed on cars and trucks, dump trucks.

The used car in Moscow, Zul-ZOA, designed for cleaning stalls and prilotkovyh sites of city streets and roads in the winter of snow remaining after the passage snegopogruzchika, as well as snegoochistki pavement traffic tunnels. In summer, this machine is used to clean up the strip from Ground prilotkovoy sediment, and sweeping the roadway of streets and roads with a large infestation.

Special equipment installed on the vehicle chassis ZIL-130 and includes the bin and the three section main brushes, conveyor system moisture estimates (for operation in the summer), the bunker for the estimates, buoyant slab for unloading hopper and hydraulic drive and control system.

During the snow removal budget, or when moving the machine forward flume brush sweeps snow from the tray and move it to the main brush, which throws the retractable material in the bucket conveyor and finally Strips coated and prilotkovuyu band. The conveyor fills with snow, or estimates hopper bins. Unloaded silo unloading a nomination to the right vertical plates at the same time opening the door of the bunker. For the base frame longitudinal chassis attached ladders welded frame, the middle part of which is the hopper for snow and estimates. In this frame establishes the basic mechanisms of the machine, except for the trough brush. On the back wall of the hopper pivotally suspended from the conveyor by means of levers and the main brush, which are installed in the vehicle and the operating position cylinders.

Back (home) brush mounted on hinge on the production line consists of three interconnected by universal joints, cylindrical sections with nylon bristles arranged at an angle to each other. The central section is set perpendicular to the longitudinal axis of the machine, and the two sides - at an angle of 15 °.

We recommend to look

• Power transmission spreader
  Power transmission drives the spreader conveyor drive and tipping the spreading equipment. Its main elements - the PTO, drive shaft, gear drives the conveyor, conveyor chain, hydraulic drive. The torque from the transmission base car passed the lower power takeoff shaft to the pump drive the spreading disk, and the top (through the drive shaft) - on the pump drive belt. [...]
• Management of special equipment
  All management of special equipment is located in the driver's cab. The torque from the motor base unit is transmitted through the PTO, protective sleeve, hand-outs and conical gears on the drive shaft and the shaft conveyor screw feeder, as well as to drive the main brush. The second (upper) power takeoff shaft is used to drive the oil pump gear. Hydraulic drive car is [...]
• Remixer
  Remixer - is, in fact, the car "Repaver", equipped with additional dosing and mixing units. Warmed up the old asphalt coating loosen knives, and then screw valve and located behind the blade is fed into the mixing unit equipped with two shafts. Fresh mix from the hopper conveyor enters the dosing unit, which sends it to the mixer, where the old and the new mass [...]
• The drive compressor
  The drive is made ​​from the compressor PTO engine GAZ-53A through the gearbox, driveline and transmission belt. On the gear drive compressors mounted gear pump NSh-10E, which serves the work of hydraulic machines. In the working position hopper hydraulic cylinder rises thermos, allowing automatic translation of the bucket truck-mounted on the rear bodywork and manual vibratory rollers of the transport to working position. Bucket-truck [...]
• Winter equipment machines KO-708
  Winter equipment machines KO-708 consists of a plow, brush and cylindrical hopper-spreader. Plow blade with a rubber knife, mounted on the front of the lift frame chassis with software manually turning it left or right while moving. Up and down the plow to the vehicle and the working position by means of hydraulic cylinders. Winter equipment consists of a brush, and frame her head [...]