FOR DE-machine is based on the self-propelled chassis of the T-16M. Special equipment of this machine consists of a compressor, tanks, paint and solvent, the receiver, the working body, the pipeline system with remote control and remote-gun spray gun. Operating equipment is mounted on a welded a platform fixed to the frame chassis. the front car to withstand the direction of movement when working set sighting device. machine works as follows. Compressed air from the compressor, the drive is performed on the engine chassis and driveline through a belt transmission, goes to the receiver and then (simultaneously) in the tanks for paint and a paint sprayer. Displaced from the tank enters the paint spray gun, where, mixing with the incoming compressed air from the receiver forms a dispersed two-phase mixture which is sprayed through the spray gun nozzle on the pavement. To wash off the paint system used solvent that is forced out of his tank by compressed air supplied from the receiver, and served in kraskoprovody, the nozzle and the ink tanks.
Maybe manual and automatic control of the nozzle with the help of an electronic unit, which consists of a transmitter, the software unit and the executive body. The converter consists of a dimensional wheel drive and pitch sensor pulses. The program is built on a unified bloc of non-contact elements of the series "Logic-T", which form the impulse to turn the executive body of the program "Bar" and a pause - the program "Gap." Executive authority is the electro-valve BB-32SH, which produces a pneumatic output pulse, allowing the needle to raise the latch, and provide entry into the mixing chamber of paint spray gun.
The machine is equipped with an additional gun, paint sprayer, and a jet pump for mechanical filling of tanks, and paint thinner.
Tags: hardware , device , chassis We recommend to look
- Sidewalks-sweeper TUM-975
Sidewalks-sweeper TUM-975 has special equipment mounted on a special self-propelled chassis, performed on three-wheel circuit with front drive and rear steering axles, which consists of a dual wheel. Daylight saving equipment consists of two main chute and a cylindrical brushes, hopper, and estimates of the type of pneumatic dust control. At the bottom of the hopper set screw, which provides unloading of [...] - The distribution of mineral and chemical products
For the distribution of minerals, chemical materials on the surface of the pavement of city streets, thoroughfares, squares and roads using special machines - spreaders (distributors), mounted on a car chassis (or trailers), permanently fixed or quick release hardware. Special equipment distributor is out of the bunker with supplies of materials, the mechanism of the material in the spreading device and of the spreading device. By type of performance [...] - The working body plow DE-210
The working body plow DE-210 is attached to the front of the machine frame longitudinal chassis and in the position of the skis is based on clean snow from the surface of the pavement. In the transport state of the working body holding device is fixed to the upper position. To install a working snowplow equipment on the chassis of ZIL-131 needs some refinement of its design - it is necessary to remove the front buffer [...] - Sweeping equipment
Sweeping up the equipment frame, tapered gear, cylindrical brush, chain drive with damper device chain hoist brushes. The brush is installed between the front and rear wheels at an angle of 62 ° to the longitudinal axis of the machine. The torque on the shaft of the brush is passed from the bottom of the shaft of the transfer case through the propeller shaft, conical reducer and chain drive. Frame brushes, consisting of [...] - Machine DE-10
Machine DE-10 is a mobile cart with a manually controlled located on it termoinstrumentom and fuel tank. Compressed air is the working body and the fuel tank is fed from an independent compressor and an electric current to ignite the combustible mixture in the combustion chamber of the burner - the car battery. Asphalt concrete pavement cut the gas stream at a temperature of 1000 ° C, cutting cracks [...]
Loading ... 
