Mechanic on duty after reading the list and volume of work carried out during maintenance, the list of machines makes an adjustment, going to the line.
In the morning the driver inspects the vehicle and making sure its good condition, the dispatcher receives a pre-drawn waybill, which makes for the exit of the garage mechanic on duty. If a waybill is signed mechanics, confirming that the car was inspected and found to be intact, the mechanic on duty controls only its appearance, in the absence of a signature on duty mechanics is re-inspection of the car. If the inspection before leaving the machine on the line driver has found a fault, he shall so inform the mechanic on duty checkpoint. If necessary, repair the mechanic on duty writes a tally sheet, passes it to the head of a dispensary, and the car goes into the zone of repair. Daily production at the end of the line of duty on machinery mechanic sends all sheets of accounting techniques to account for, which (after processing) to dock with facial cards, indicating the required replacement units and units, and places of special cells in the cabinet, whose numbers correspond to the numbers of machines.
After repairing the driver makes the car decorated with a piece of accounting mechanics of the checkpoint, who inspects it and issues in the absence of fault on the line, and the tally sheet to record transfer technique.
Tags: repair We recommend to look
- The energy balance of machines
The energy balance of these machines in operation include (depending on the technology works): the cost of power to drive the bitumen pump, defined as vehicles for transporting and distributing bitumen, cost of power to drive the compressor is defined as machines that destroy the hard cover, the cost of power to drive the mixer to be taken when mixing the mastic in the boiler with a capacity of 0.8-1 [...] - Power AB-4T/230
Power AB-4T/230 4 kW electric motor provides power to drive the compressor, bitumen pump system of distribution of binder and water pump "Kama-3" to feed 1.5 m3 / h, two elektromolotkov C-849 and elektrovibrokatka. The system includes binder heating fuel tank with pressure gauge and safety valve, piping, two-burner evaporative type. Bitumen boiler has an automatic control system heating mode binder. [...] - Generator ESS-81-4
Generator ESS-81-4 provides 20 kW of electricity consumers. The drive of the generator from the motor shaft base unit via PTO, driveshaft, intermediate support and the V-belt transmission. The compressor provides the blasting and spray charts. Elektrovibrotrambovka designed to seal freshly placed mass with a width of the repair area is less than 500 mm. Elektrovibrokatok used to seal freshly placed mixture to [...] - Operation of Watering-washing machines with a defective bracket Tank
Operation of Watering-washing machines with a defective fastening the tank valve or damper central nozzle is prohibited. For operation and maintenance of watering-washing machines are prohibited: 1) check the oil level, fill the oil, pull the seal during operation of a centrifugal pump, and 2) to move the machine with the sleeves neulozhennymi diversions, 3) fill the tank with water from the water with the engine running the machine. It is strictly forbidden to perform at [...] - Cost-effectiveness of interventions to improve the use of machines
Improving the technical operation of special vehicles - the most important means of improving the efficiency of fleet vehicles, which provides an increase in the total number of hours of machine operation during the year, as well as reducing intra simple machines. The increase in the total number of hours of work achieved by increasing the shift coefficient, reducing the number of days of machine downtime due to organizational reasons, reducing the time to produce periodic in [...]
Loading ... 
