Components and assemblies for the machine KO-705 is carried out control osmotrovye work (check the backlash in the joints and driveshafts splines drive the state of painting equipment tractors) and check the basic components and parts;
tractor with accessories - earrings position of the front frame, fixing bolts hinge covers driveshafts, sealing cap shell intermediate support the driveshaft, the selection box [...]
For the sweepers - prior to placement on the long-term storage of wash and wipe the chassis, all the mechanisms and wiring, pre-clearing them of dirt and dust. Check the technical condition of the car - faulty nodes removed and repaired. In each cylinder engine is shipped 30-50 g of motor oil, turning several times crankshaft. All unpainted metal [...]
Labor Standards TS-1 and TO-2 does not include the complexity of daily and seasonal maintenance. Standards of labor costs for technical or railway station are not included labor costs for ancillary works, which are set in the range of 20-30% of the total complexity of maintenance and minor repairs on spetsavtobaze (a smaller percentage adopted for large spetsavtobaz greater - for medium and small). The [...]
Mechanic on duty after reading the list and volume of work carried out during maintenance, the list of machines makes an adjustment, going to the line.
In the morning the driver inspects the vehicle and making sure its good condition, the dispatcher receives a pre-drawn waybill, which makes for the exit of the garage mechanic on duty. If a waybill is signed mechanic, confirming that [...]
Disconnect the drive shafts and gears drive the spreading scraper conveyor, removing the bolts back side of the body, removed her fingers attaching the tailgate and remove it with a gear drive. Disconnect the welded bracket and the spreading disk of the machine frame and remove it along with spreading disc and the drive gear. Disconnect propeller shaft drive gear and distributing [...]
To conduct snegopogruzchikov control osmotrovye work (check tightness and tighten if necessary, seal the box changes gears, creeper, second clutch, splitter, handout and intermediate gearboxes, clutches limit torque, conical, and chain gear cutters, gear drive drum of the conveyor) and check the basic components and parts:
a milling feeder - drive chain tension reducer mill (in the case of [...]
